Toshiba B-480-QQ - Manual (Page 8)

E2-2
2. SPECIFICATIONS EO1-33008
2.2 Option
2.2 Option
Option Name
Swing cutter module
Rotary cutter module
Peel off module
Ribbon saving module
Fanfold paper guide
module
PCMCIA interface
board
Expansion I/O
interface board
Usage
A stop and cut swing cutter
Rotary cutter
This allows use of on-demand (peel-off) operation or to
rewind labels and backing paper together when using the
rewind guide plate. To purchase the strip module, please
inquire at your local distributor.
This module moves the print head up and down by using a
solenoid to save the ribbon loss as far as possible. To
purchase the ribbon saving module, please contact your
distributor or TOSHIBA TEC HQ can assist in finding one
for you.
This is a paper guide exclusively used for fanfold paper.
Attaching it in place of the standard paper guide allows the
printer to print on fanfold paper.
This board enables the following PCMCIA cards to be used.
* LAN card: 3 COM EtherLink
® III (recommended)
3 COM 3CCE589ET (recommended)
* ATA card: Conforming to PC card ATA standard
* Flash memory card:1MB and 4MB cards (See Page 7-1.)
Installing this board allows connection to external device.
Type
B-4205-QM
B-8204-QM
B-4905-H-QM
B-4905-R-QM
B-4905-FF-QM
B-8700-PC-QM
B-8700-IO-QM
Type
Width
Length
Outer diameter Spool type
68 mm ~ 112 mm
600 m
ø90 mm (max.)
2.3 Ribbon
NOTES: 1. "On the fly issue" means that the printer can draw and
print without stopping between labels.
2. To ensure print quality and print head life use only
TOSHIBA TEC specified media and ribbons.
3. When using the cutter ensure that label length B plus
inter label gap length E exceeds 35 mm. (i.e. label
pitch should be greater that 35 mm.) (See Page 2-3.)
4. When rewinding the media onto the take-up spool in
batch mode, the max. outer roll diameter should be 180
mm.
5. Use of rough media for the ribbon saving issue may
cause ribbon smudges.
NOTE: To purchase the OPTIONAL KIT, please contact your authorized TOSHIBA TEC representative
or TOSHIBA TEC Head Quarter.