Toshiba B-480-QQ - Manual (Page 23)

E9-3
9. GENERAL MAINTENANCE EO1-33008
■ Cleaning the Cutter Unit
9.3 Removing Jammed Paper
The swing cutter and rotary cutter are available as an option. They are both cleaned in the same way
regardless of different shapes. Now, how to clean the cutter unit installing the swing cutter will be
introduced.
1. Loosen two screws and remove the cutter cover.
2. Remove the white screw and media guide.
3. Remove the jammed paper and trash.
4. Clean the cutter with dry cloth.
5. Assembling is reverse order of removal.
Fig. 9-3
Fixed Cutter
Cutter Unit
Swing Cutter
Screw
Media Guide
Cutter Cover
White Screw
(24741710304)
WARNING!
1. Be sure to turn the power off before cleaning the cutter unit.
2. The cutters are sharp and care should be taken not to injure yourself when cleaning.
■ Auto Ribbon Saving Mode
Auto ribbon saving function is activated when a no print area extends more than 17 mm.
For further information on this function, please ask your nearest TOSHIBA TEC service representative.
NOTE: According to the relation between the outer diameter of rewound ribbon and print speed, ribbon
loss per saving varies as follows:
Print speed
3"/sec.
5"/sec.
8"/sec.
Ribbon loss
Approx. 5 mm
Approx. 8 mm
Approx. 17 mm