Toshiba B-480-QQ User Manual

Page 13

E5-2

5. LOADING THE MEDIA

EO1-33008

5. LOADING THE MEDIA

4. Put the media on the supply shaft.
5. Pass the media around the damper, then pull the media towards the front of the printer.
6. Insert the ridge of the supply holder into the groove of the supply shaft until the media is fixed. Then turn

the locking ring clockwise to secure the supply holder. This will centre the media automatically.

NOTE:

Do not over tighten the locking ring of the supply holder.

7. Insert the media into the paper holders of the media guide, adjust the media guides to the media width,

and tighten the locking screw.

8. Check that the media path through the printer is straight. The media should be centered under the print

head.

NOTE: When using the label rolled with labels facing outside, please remove the upper plates of both

paper holders using the following procedure. Failure to do this may cause a paper jam error.

If you have any questions, please contact your nearest TOSHIBA TEC service representative.

Fig. 5-3

Fig. 5-4

Media

Paper Holder

Locking Screw

Media Guide

Supply Holder

Paper Holder

Print Head

Media

Supply Holder

Supply Shaft

Damper

Groove Ridge

Projection