Tiger Products Co., Ltd JD 72-7520 - Manual (Page 34)

Assembly Section 2-10
ASSEMBLY
MANUAL VALVE MOUNTING (WO/CAB)
Refer to the parts section, lift valve page for hardware and location of
components. First, attach control valve stand to the top of the main frame mast with
cap-screws, lock-washers and hex nuts. NOTE: The mounting plate should face
the rear of the tractor.
Attach the 3-spool control valve to the stand using the hardware noted in the
parts section. One cap-screw must be used to secure the switch box to the under
side of the valve stand.
INSTALLING O-RING FITTINGS
Installing straight, 45 degree and 90 degree O-ring fittings requires that the O-ring,
washer and nut (A) be up against the swivel body (B). Insert the swivel and turn in
until the swivel is pointed in the right direction and O-ring contact is made. Hold
swivel in set direction with a wrench and turn the O-ring nut away from the swivel
body and carefully tighten.