Toshiba B-450-HS-QQ - Manual (Page 18)

8-3
EO1-330019
8. LOADING THE PAPER
8. LOADING THE PAPER
10. For details on changing the black mark sensor position according to the black mark position, refer to
the Section “Setting the black mark sensor position”. When using the round or pre-printed label, refer
to the Section “Setting the feed gap sensor position” and adjust the sensor position.
11. Draw the label onto the platen. Close the sensor cover and return the lock lever to lock the sensor cover
tight.
12. Close the print head block by pressing both sides of the print head block’s top until it clicks.
Fig. 8-7
Head Block
Fig. 8-8
Supply Holder
Paper Guide
Paper Platen
A
B
A = B
.
.
NOTE: Pass the paper straight from the supply holder to paper outlet. Failure to do this may cause
skew feeding or paper jam.