TANDBERG 990 - Manual (Page 94)

94
TANDBERG Videoconferencing System Peripherals
5 Video Inputs
• 1 video input used by the built-in camera.
• 1 video input supporting S-Video through a Mini-DIN connector.
• 2 video inputs supporting composite signals through RCA connectors.
• 1 VGA input supporting resolutions VGA(640x480), SVGA(800X600) and XGA(1024x768) (auto sensing).
The system will automatically adapt to a PAL or NTSC input.
4 Video Outputs
• 1 S-Video output, Mini-DIN connector.
• 2 composite video outputs, RCA connectors.
• 1 VGA output supporting resolutions VGA(640x480), SVGA(800X600) and XGA(1024x768).
The first Mini-DIN connector and the first RCA connector provide main video (incoming/outgoing video and menus).
The other connector provide selfview/still image/Duo Video. The outputs are always active.
The format of the output will be either PAL or NTSC depending on your country’s standard video format.
4 Audio Inputs
• 2 microphone inputs (balanced, 11V phantom powered) via XLR connectors.
• 2 audio inputs (line level) via RCA connectors.
All audio inputs are active by default. For further information, refer to section ‘Audio Settings’.
2 Audio Outputs
• 1 output (line level) via RCA connector providing audio from far end in addition to dial tones. This output is used
by the monitor.
• 1 VCR output (line level) via RCA connector providing a mixed signal between audio from the local side (except
from the VCR input) and audio from the far end. This output is intended for connection to a VCR.