TANDBERG 990 - Manual (Page 103)

TANDBERG Videoconferencing System
103
Appendices
Appendix 4: Using the file system
It is possible to access a file system within the TANDBERG system by using ftp:
DOS-window:
ftp , or
Web-browser: ftp://
Description of the different files
all.prm
- all settings in the system (including directory)
dir.prm - directory entries
event.log - logs fault sitations etc.
sw.pkg - the system software
globdir.prm - file containing up to 400 entries. These entries can not be edited from the TANDBERG Videoconferencing
system, but can be edited as a text-file.
Files accessible only by ‘ftp get /tmp/snapshots/xxx.jpg’ or ‘http:///tmp/snapshots/xxx.jpg’:
main.jpg
- Snapshot of current stream if MultiSite.
local.jpg - Snapshot of selfview
farend.jpg - Snapshot of decoded stream if point-to-point.
duovideo.jpg - Snapshot of the encoded stream if transmitting DuoVideo, the decoded stream if receiving
DuoVideo.
Description of the different folders
user
- a folder to be used for custom logos etc.
remote - a folder used for software upgrade of the far end TANDBERG system
What can be done by using the file system?
· software upgrade of the far end TANDBERG system (B3 or above) via ISDN
· upload of custom logos
Software upgrade
· Connect to the system you want to upgrade using ISDN.
· Copy the software file to a folder on your harddisk.
· Open a DOS-window and go to this folder.
· Type ftp .
· Enter password:
· Go to the remote folder, type “cd remote”
· Upload the software file, type put
· Wait until the following is shown:
226 Closing data connection.
5437569 bytes sent in 808.01 seconds (6.73 Kbytes/sec)
ftp>
· Restart the far end codec.
The far end system should now be upgraded. For further information, please contact your TANDBERG representative.