TANDBERG 990 - Manual (Page 31)

TANDBERG Videoconferencing System
31
General use
Presets
The preset buttons enable you to pre-store up to ten different settings. Each preset is able to store:
• Video source
• Camera position, pan/tilt/zoom/focus/brightness (if Main Camera)
• Audio source selection (see ‘Audio Settings’ in ‘Advanced use’)
Selecting presets
To select a pre-stored camera position, audio and video source, use the keys P1 P2 P3 or press P until the on-
screen indicator ‘Preset 0-9’appears and use 0-9 to activate P0-P9 presets. To exit ‘Preset’ mode, press O
K .
P1-P3 are the same presets as when pressing P and then a number key 1-3.
Storing presets
To store the current camera position, audio and video source:
• Press S TORE once and wait for the on-screen indicator to appear.
• Then press one of the keys P1 P2 P3 or a number key 0-9.
store
P 1 P 2 P 3
Storing preset 10 to 15
To store preset 10-15 the TANDBERG Tracker has to be used:
• Select which preset to be used on the TANDBERG Tracker (see separate documentation).
• Press S TORE once on the TANDBERG Remote Control and wait for the on-screen indicator to appear.
• Then press the ‘single person’ button on the TANDBERG Tracker.
See the Tracker section in ‘Peripheral Equipment’ for more information about the TANDBERG Tracker.
0 1 2
3
4
5
678
9A
B
C
D
E F