System configuration – TANDBERG 990 User Manual
Page 15
TANDBERG Videoconferencing System
15
Installation
System configuration
• Switch the system on by activating the power switch on the system.
• After the system has performed a self-test routine, product logo and a ‘Welcome’ menu will be displayed on the
monitor.
connect
menu
P
RESS
M
ENU
ON
THE
REMOTE
CONTROL
. S
ELECT
THE
MENU
‘T
ERMINAL
S
ETTINGS
’, ‘N
ETWORK
’, ‘ISDN-BRI
SETTINGS
’. S
ELECT
THE
RELEVANT
‘L
INE
S
ETUP
’
MENU
AND
SET
‘E
NABLED
: O
FF
’.
• Enter System Name to identify the system during an MCU conference. Select ‘Utilities’, ‘System Name’ and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in ‘Terminal Settings’, ‘Language’.
• If you are using two monitors, set ‘Utilities’, ‘Dual Monitor: On’.
• To activate MultiSite and/or Presenter, enter an option key (see paperwork accompanying your system), see
‘Terminal Settings’, ‘Software Options’.
• Press C
ONNECT
on the remote control. A dial tone should be heard if the network is active.
• Using the monitor remote control, adjust the volume on the monitor to a level of your choice. This
volume will be the default volume for all calls.
T
HESE
SETTINGS
ARE
ESSENTIAL
FOR
OPTIMAL
SYSTEM
SET
-
UP
.
NOTE
• Enabled but unused ISDN lines (lines not active) should be disabled. Select the Quick Key ‘System Info’ (on
the remote control) to view line status.