Toshiba 42H83 - Manual (Page 15)

Intr
oduction
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V’s
F
eatur
es
Appendix
Index
15
( )
Note:
Your TV’s remote control may not operate
certain features on your VCR, cable TV
converter, or other electronic device.
Refer to the owner’s manuals for your other
devices to determine their available features.
If your TV’s remote control does not operate a
specific feature on a device, use the remote
control that came with the device.
Caution:
• Dispose of batteries in a designated
disposal area. Do not throw batteries into a
fire.
• Do not mix battery types or combine used
batteries with new ones.
• If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace both batteries with new
ones.
• If the batteries are dead or if you will not
use the remote control for a long time,
remove the batteries to prevent battery acid
from leaking into the battery compartment.
1 2 3
4 5 6
7 8 9
ENT 100 0
CH
VOL
POWER
TIMER
RECALL
TV/VIDEO MUTE
TV
CABLE
VCR
CH RTN
PIC SIZE
EXIT
LIGHT
STOP SOURCE
ADV/
POP CH
ADV/
POP CH
FAV FAV
PLAY POP
REC TV/VCR REW FF
STILL SWAP
FAVORITE
MENU/
C.CAPT
ENTER
TV/CABLE/VCR
POWER
Channel yz
Chanel
Number
Enter
PLAY
STOP
Fast Forward
Rewind
TV/VCR
Record
Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most VCR
models, and cable TV converters together, even if they are different
brands. If you will be using your TV with a Toshiba VCR, your
remote control is already programmed and ready to use. If you own
different brands of VCRs and/or converters, you first have to program
your remote control. (See “Programming the remote control for use
with a non-Toshiba VCR or cable TV converter” on page 16.)
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off the back of the remote control.
2. Install two “AA” size alkaline batteries. Match the + and - signs on
the batteries to the signs on the battery compartment.
3. Slide the battery cover back on to the remote control until the
lock snaps.
Using the remote control with a VCR or
cable TV converter
If you own a non-Toshiba device or a Toshiba device that the remote
control is not preprogrammed to operate, you must program the remote
control to recognize your device. See page 16.
To control a VCR:
Set the TV/CABLE/VCR switch to the VCR position. The
buttons shown at right will then control the VCR. The unshaded
buttons will operate the TV as usual.
(Continued on next page)