Toshiba 15CV101U - Manual (Page 34)

34
Chapter 6: Using the TV’s features
Input labeling example:
The screen below is an example of how you could
label the inputs if you connected a VCR to Video,
a Video Recorder to HDMI 1, and a DTV set-top
box to HDMI 2. Also note that the ColorStream
HD input is labeled “Hidden”, which means that
input will be skipped over when
is pressed.
To clear the input labels:
Tuning channels
Setting the Channel Tuning Mode
This feature allows you to choose how tuning will
be handled for analog and digital channels when
the TV is in Antenna mode.
Note: To use this feature, the Input
Configuration must be set to Antenna (
Page 28).
The channel tuning mode has three options.
Note: Even if the Channel Tuning Mode is
set to Digital, analog channel 3 will still be the
default channel to prevent the initial case
where no digital channels have been found in
prior channel scans.
Tuning to the next programmed
channel
To tune to the next programmed channel:
Press or on the remote control or PLAY/
CHANNEL
or STOP/CHANNEL on the
TV control panel.
Note: This feature will not work unless you
program channels into the TV’s channel
memory ( Page 29).
1 From the Preferences menu, press or
to select Input Labeling and then press .
2 Highlight Reset and then press .
Mode Description
Standard
Both analog and digital channels can
be tuned normally.
Auto
(Default)
Digital channels will have priority
when manually entering a channel
number using the Channel Number
buttons (0-9) on the remote control,
analog channels can still be tuned by
or , if available.
Digital Only digital channels can be tuned.
1 From the Setup menu, press or to
select Installation and then press .
2 Press or to highlight Terrestrial, and
then press or to select Channel
Tuning Mode.
3 Press or to select your desired mode.