Tripp Lite 500 - Manual (Page 2)

Built-in dataline suppression jacks protect a single dialup phone/DSL line or network Ethernet line connection
Built-in audible alarm and 3 front-panel LEDs indicate line power, battery power and battery low/replace status
500VA/280W power handling ability supports a variety of computer, internetworking, telecom and consumer electronics equipment
Supports user battery replacement via built-in access panelCompatible with 120V/60Hz applications for USA, Canada, Mexico and more
$150,000connected equipment insurance (USA, Puerto Rico, & Canada only)
Specifications
OUTPUT
Output Volt Amp Capacity
(VA) 500
Output Watt Capacity
(watts) 280
Nominal Output Voltage(s)
Supported 115V; 120V
Frequency compatibility 60 Hz
Output voltage regulation
(Battery mode) 115V (+/- 5%)
Built-in UPS output
receptacles 6 5-15R outlet(s)
Surge suppression only
outlets 3 UPS outlets, 3 surge-only outlets
Output AC waveform (AC
mode) Sine wave
Output AC waveform
(battery mode) PWM sine wave
INPUT
Rated input current (at
maximum load) 10A
Nominal Input Voltage(s)
Supported 120V AC
UPS input connection type 5-15P
UPS Input cord length (ft.) 6
UPS Input cord length (m) 1.8
Recommended Electrical
Service 15A 120V
Input cord length (ft.) 6
Input cord length (m) 1.8
BATTERY
Full load runtime (minutes) 4.6 min. (280w)
Half load runtime (minutes) 14.8 min. (140w)
DC system voltage (VDC) 12
Replacement battery
cartridge (internal UPS
battery replacement) RBC51
Battery Access Battery access door