Telex PAM-32 - Manual (Page 25)

23
Service Menu
NOTE: Once you have entered the Netmask, you may need to enter the Gateway IP Address. A Gateway is a node (for
example, a computer) on a network that serves as an entrance to another network.
16. Press PGM.
The actual Gateway IP Address appears.
17. Enter the first number in the Gateway IP Address.
This activates the first octet of the Gateway IP Address and clears the rest of the address.
18. Press PGM.
This confirms the first octet of the Gateway IP Address and moves you the second octet.
NOTE: Press PGM to skip over any octet that does not need modifications.
19. Repeat steps 19 and 20 until the entire Gateway is entered.
20. Press PGM.
21. Press CLR to exit the menu.
The changes are now enabled.
Service Menu, Save Cfg
Save Cfg PGM saves custom settings that you have made in the Key Option or Service menus. After customizing settings in
Key Option and Service menus, run Save Cfg to store your custom settings in non-volatile memory. This will assure protection
of your settings when the keypanel is powered down. To erase all custom settings, run Services Menu, Reset Cfg.
Service Menu, Scr Saver
A screen saver is an animated image that is activated on a display when no user activity has been detected for a certain time.
To set the screen saver delay time, do the following:
1. On the PAM-32, press Menu.
Display appears in the keypanel display.
2. Press ⎠⎠ to scroll to service.
3. Press PGM.
Aux inputs appears in the keypanel display.
4. Press ⎠⎠ to scroll to Scr Saver.
5. Press PGM.
Delay appears in the keypanel display.
NOTE: There are three options to choose from this list: Delay, DSP OFF, and Activate. When DSP Off is selected, the
keypanel display turns off (pressing any key will re-activate the display). When Activate is selected, the screen
saver is immediately enabled. (pressing any key will re-activate the display). Delay allows you to set a specific
amount of time the keypanel is inactive before the screen saver engages.
6. Press PGM.
30 min appears on the keypanel display.
Using ⎠⎠ scroll through the following times to determine how much inactivity on the keypanel must pass before the screen
saver is activated.
30 min
1 hr
2 hr
4 hr
6 hr