Telex PAM-32 - Manual (Page 19)

17
Menu System, Key Assign Menu
6. Tap PGM or FWD to select a list. In some cases Wait may display while the requested list is uploaded from the intercom
system.
Tap Key should now display.
7. Tap an available intercom key to assign a listen-only key.
If you assign a key that is listen only, the assignment will appear briefly in upper-case letters, then will change to lower-
case letters.
NOTE: when reassigning keys remember to remove any Chime, solo, or Key Group options if they will not be needed for the
new key assignment.
Key Assign Menu, Matrix
Matrix appears only for trunked intercom systems. You must select a remote intercom matrix before assigning intercom keys
to destinations in that matrix. You do not need to select matrix to assign keys to destinations in your own matrix. You also do
not need to select a matrix when assigning an auto-function to a key.
Key Assign Menu, Pt-to-Pt
Assigns a key that listens to another intercom port. Note, some pt-to-pt destinations may be non-keypanel devices that cannot
activate listen paths. Therefore, if you want full communication, you may need to assign both talk and listen on the key.
Key Assign Menu, Key Gain
Use this menu item to adjust the listen gains for point-to-point assignments.
1. Press FWD or PGM to select Key Gain in the Key Assign menu.
Tap Key displays.
2. Tap the key that you want to adjust.
The current listen level displays in the Call Waiting Window.
3. Press ⎠⎠ or −− to change the listen level.
4. You may tap additional point-to-point to change their listen levels, or tap CLR to quit.
NOTE: you do not need to run Save Cfg after resetting key gains. These settings are stored in the intercom system.
Key Assign Menu, Reset Vols.
Use this menu item to simultaneously reset gains for all point-to-point keys.
1. Press FWD or PGM to select Reset Vols in the Key Assign menu.
Done displays. All key gains are now reset to the default level.
2. Tap CLR to quit.
NOTE: You do not need to Save Cfg after resetting key gains. These settings are stored in the intercom setting.
Key Assign Menu, Setup Page
Use this menu item to change the setup page assignments on the PAM-32. One setup page is used for the top row of keys, an
another setup page is used for the bottom row.
1. Press FWD or PGM to select Setup Page in the Key Assign menu.
Page 1 displays.
2. Press ¯ ¯ or -- to select any of the following:
Page 1: Assign setup page 1 to the PAM-32
Page 2: Assign setup page 2 to the PAM-32
Page 3: Assign setup page 3 to the PAM-32
Page 4: Assign setup page 4 to the PAM-32
Clear Page: Clear page assignment from the PAM-32