Service menu, reset cfg, Service menu, rvon setup – Telex PAM-32 User Manual
Page 24
PAM-32 Menu System
22
3.
Tap CLR to exit.
4.
Run Service Menu, Reset Cfg to store the Output Level settings.
Service Menu, Reset Cfg
Reset Cfg restores all custom settings to the defaults and erases all stored autodial numbers.
Service Menu, RVON Setup
NOTE: To use the RVON-1 with the PAM-32, the PAM must be at firmware version 1.0.0 or higher.
The RVON-1 card, when shipped has a default IP Address already configured. This must be changed in order for the RVON-1
card to function properly because the pre-configured IP Address may not work with your network.
To set the IP Address, do the following:
1.
On the PAM-32, press Menu.
The top level menu appears.
2.
Using the
⎠⎠, scroll to Service.
3.
Press PGM.
The Service menu appears.
4.
Using the
⎠⎠, scroll to RVON Setup.
5.
Press PGM.
The IP Address menu item appears.
6.
Press PGM
The actual IP Address appears.
7.
Enter the first number in the IP Address.
This activates the first octet of the IP Address and clears the rest of the IP Address.
8.
Press PGM.
This confirms the first octet in the IP Address and moves you to the second octet.
NOTE: Press PGM to skip over any octet that does not need modifications.
9.
Repeat steps 7 and 8 until the entire IP Address is entered.
10.
Press PGM.
The Netmask menu item appears.
NOTE: Once you have entered the IP Address, you will then enter the Netmask. The Netmask is a string of numbers similar to
an IP Address, except that it masks or screens out the network part of an IP Address so that only the host computer part of the
address remains (for example, 255.255.255.0).
11.
Press PGM.
The actual Netmask appears.
12.
Enter the first number in the Netmask.
This activates the first octet of the Netmask and clears the rest of the Netmask.
13.
Press PGM.
This confirms the first octet in the Netmask and moves you to the second octet.
NOTE: Press PGM to skip over any octet that does not need modifications.
14.
Repeat steps 12 and 13 until the entire Netmask is entered.
15.
Press PGM.
The Gateway IP Address menu item appears.