Telular SX3e - Manual (Page 8)

P
HONECELL
SX3e AMPS 8 U
SER
M
ANUAL
Step 2. Plug In Your Telephone
Connect Your Telephone:
1) Locate the modular (RJ-11) line port
on your phone and plug in one end
of a standard (RJ-11) phone cord.
2) Connect the other end of the cord
to the RJ-11 port on the back of
your Phonecell SX3e – see Fig. 6.
Place a Call – Adjust Your FWT:
1) Pick up the phone receiver and listen
for dial tone.
2) If you hear dial tone, make a call.
3) While you’re talking with the other
party, listen for static and echo. If you
hear either, move the antenna until
you find the spot where voice
conversation is strong, and static
and echo are minimized.
NOTE: If you are unsuccessful in
dialing out, it’s probably due to
one of the following:
••
The antenna location needs to be
adjusted – see Step 1, page 6-7.
••
The NAM/Phone Number needs to
be set up – see Step 3, page 9-11.
••
Your cellular phone number has not
been activated – contact your
cellular service provider.
Adding More Phones?
Plug in an RJ-11 line splitter (not sup-
plied) to connect additional phones to
your FWT – see Fig. 7. NOTE: you can
only make one phone call at a time.
Additional Telephone Equipment:
If you plan to use a device other than a
telephone with your Phonecell SX3 (such
as a modem), make sure that device will
work with a normal wired telephone line.
Fax Machines – Connect a fax machine
the same way it needs to be set up for
use on a regular wired telephone line.
PBX/KSU Systems – PABX
installation should only be performed
by experienced telephone technicians.
IMPORTANT!
Make sure the wiring from the
telephone equipment to your
Phonecell SX3 is properly
protected from all transient
voltages, including lightning.
!
Phone
Cords
Line
Splitter
Fig. 7 Optional RJ-11 Line Splitter
lets you connect additional phone
equipment to your Phonecell SX3e.
To
Fax
To Phone(s)
Phone Cord
To
Modem
RJ-11
Port
Fig. 6
The Phonecell SX3 lets you connect up to 5 pieces of standard telephone
equipment into a cellular network. Follow the steps below for quick installation.
To RJ-11 Port