Telular SX3e - Manual (Page 10)

P HONECELL SX3e AMPS 10 U SER M ANUAL
NOTE: The following NAM Parameters are automatically set by the SID value in
Step #4 on the previous page. These steps (5–7) are only needed if you want to
override the standard AMPS settings listed on the previous page. Otherwise,
continue to Step 4 – Wall-Mount or Desktop Installation, pages 12–13.
Step #5a - How to Override the Initial Dedicated Control Channel and First
Paging Channel.
If you have an “A” cellular service provider with an odd SID
(System Identifier), enter the following 2-part key sequence.
Otherwise, continue to Step #5b.
1) First press: # * 24 * _ _ _ _ #
2) Next press: # * 4 * _ _ _ _ #
(Note: enter the same 1- to 4-digit channel in both steps above.)
The spaces represent your 1- to 4-digit Initial Dedicated Control
Channel and First Paging Channel. When you turn on your Phonecell,
these channels help the service provider find you and vice-versa.
NOTE: The default setting is channel 333 for "A" service providers. To
change the setting, you must enter a 1- to 4-digit number in the range
of 0 to 1023. (For example, to set up channel 565, enter #*24*565#.) If
you enter the channel incorrectly, you'll hear three short tones followed
by the programming tone; if correct, you'll hear the programming tone
again.
Step #5b - If you have a “B” cellular service provider with an even SID
(System Identifier), enter the following 2-part key sequence.
1) First press: # * 25 * _ _ _ _ #
2) Next press: # * 4 * _ _ _ _ #
(Note: enter the same 1- to 4-digit channel in both steps above.)
The spaces represent your 1- to 4-digit Initial Dedicated Control
Channel and First Paging Channel. When you turn on your Phonecell,
these channels help the service provider find you and vice-versa.
NOTE: the default setting is channel 334 for "B" service providers. To
change the setting, you must enter a 1- to 4-digit number in the range
of 0 to 1023. (For example, to set up channel 566, enter #*25*566#.) If
you enter the channel incorrectly, you'll hear three short tones followed
by the programming tone; if correct, you'll hear the programming tone
again.
NAM/Phone Number Setup – Override Commands
Continued...