Telular SX3e - Manual (Page 22)

P HONECELL SX3e AMPS 22 U SER M ANUAL
AMPS Technician Programming
AMPS Technician Programming Commands
The Phonecell SX3 can be programmed on location with an ordinary telephone,
which is sometimes referred to as a POTS (Plain Old Telephone Set) phone.
NOTE: the Technician Programming mode is not accessible while in a call.
In the following sections, an is comprised of the digits 0 through
9. The digits '*' and '#' are considered invalid when used inside an value>, and will cause that command/value to be rejected.
When you enter the programming mode, a timer is started. If there are no key
entries within any 2-minute period, the FWT will revert to its normal mode. Going
on-hook (hanging up the phone) will exit the programming mode.
How to Enter the Technician Programming Mode
Use the following access code to enter the Programming mode:
Press: # * 0 * 1 2 3 4 4 3 2 1 #
The access code is 8 digits. If the access code is not 8 digits or does
not match the stored access code, the Technician Programming mode
cannot be not entered. This code is pre-programmed during production
and cannot be changed in the field.
If you enter the access code correctly, the dial tone should change to a
different, steady “Programming” tone and the LED indicator on the front
of the Phonecell will blink alternately RED and GREEN to indicate that
you’re in the programming mode.
IMPORTANT!
The following commands may be used by a trained service technician to
change the configuration of the Phonecell SX3. WARNING: these commands
are intended for use by trained service technicians only. Untrained users could
damage the Phonecell, violate local regulations and breach the service agree-
ment with the cellular provider. For further assistance, please contact
your Authorized Telular Representative.
!