Telular SX3e - Manual (Page 23)

P HONECELL SX3e AMPS 23 U SER M ANUAL
How to Set the Access Overload Class (ACCOLC)
Use the following key sequence to set the ACCOLC:
Press: # * 2 * < ACCOLC > #
The < > brackets represent the 2-digit ACCOLC. You must enter a
2-digit value between 00 and 15, otherwise the FWT will not update
or store this value; the existing stored parameter will remain. (For
example, to program the FWT for ACCOLC 8, enter: # * 2 * 08 #.)
How to Set the Access Method (EX) Option
Use the following key sequence to set the EX option:
Press: # * 3 * #
The < > brackets represent the 1-digit EX option:
enter: 1 if the FWT must always send the full MIN (Mobile
Identification Number) when accessing the system
enter: 0 if not.
You must enter either 0 or 1, otherwise the FWT will not update or
store this value; the existing stored parameter will remain. The factory
default setting is 1.
How to Set the Roam Option
Use the following key sequence to set the Roam option:
Press: # * 6 * #
The < > brackets represent the 1-digit Roam option:
enter: 0 to enable roaming
enter: 1 to disable roaming.
You must enter either 0 or 1, otherwise the FWT will not update or
store this value; the existing stored parameter will remain. The factory
default setting is 0.
How to Set the Dial Tone After Remote On-Hook Option
Use the following key sequence to set the Dial Tone After Remote
On-Hook option:
Press: # * 8 * #
The < > brackets represent the 1-digit dial tone option:
enter: 0 for no dial tone after a remote on-hook
enter: 1 to enable dial tone after remote on-hook.
You must enter either 0 or 1, otherwise the FWT will not update or
store this value; the existing stored parameter will remain. The factory
default setting is 1.
Technician Programming Commands – Continued