Toshiba BDX2500KU - Manual (Page 7)

7
Introduction
Identification of Controls
Front panel
Rear panel
1 2 3 4 5 6
7 8 9
AC IN
LAN MULTI CHANNEL AUDIO OUTPUT
R
AUDIO OUT
L
VIDEO
OUTPUT USB HDMI OUT
BITSTREAM / PCM
OPTICAL
Y P B P R
SBL C SL FL
SBR SW SR FR
COMPONENT VIDEO OUT
1 2 3 4 5 6 7
8 9
5
1. Disc tray
2. OPEN/ClOSE button
3. Display
• Refer to “Front Panel Display” on page 10.
4. Remote sensor
5. STOP button
6. PlAY button
1. AC power cord
• Connect to a standard AC outlet to supply power to this
unit.
• Unplug this cord from the AC outlet to completely turn
off the unit.
2. lAN terminal
• Use to connect a network equipment with LAN cable.
3. HDMI OUT jack
• Use to connect a TV with an HDMI compatible port via
an HDMI cable.
4. OPTICAl jack
• Use to connect an AV receiver / amplifier, Dolby Digital /
DTS decoder or other device with a digital audio optical
input jack using a digital audio optical cable.
7. ON/STANDBY indicator
8. SD card slot
9. ON/STANDBY button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you must
unplug the AC power cord.)
5. COMPONENT VIDEO OUT jacks
• Use to connect a TV with component video inputs using
a component video cable.
6. MUlTI CHANNEl AUDIO OUTPUT jacks
• Use to connect an AV receiver / amplifier with a audio
cable.
7. USB jack
• Use to connect USB flash drives (not included).
8. AUDIO OUT jacks
• Use to connect a TV, an AV receiver / amplifier or other
device with a composite audio cable.
9. VIDEO OUT jack
• Use to connect a TV, an AV receiver or other device with
a composite video cable.