Tascam IF-DM - Manual (Page 21)

21
2. Select VST Multitrack
3. Select IFFWDMmkII under the ASIO Driver pull down
menu
4. If it was not already selected, a dialog will popup asking
whether it is OK to switch to the new ASIO driver. Click
Switch
5. Click OK at the bottom.
Sonar
The following instructions are for Sonar 4 or later.
1. Select Audio under the Options menu
2. Click the Advanced tab and select “ASIO” for the Playback
and recording Driver Mode.
3. If ASIO was not already selected, you will need to quit
Sonar and restart, and then navigate back to this Audio
dialog.
4. Click the Drivers tab and enable the desired Inputs and
Outputs, they will be labeled ASIO IFFWDMmkII In 1,
ASIO IFFWDMmkII In 3 etc. You may need to unselect all
of the items in these lists before the application allows you
to select the Firewire card’s audio streams. If the 16
channel mode was selected in the mixer, only 16 channels
(8 pairs) will be visible here, otherwise 32 channels (16
pairs) will be available for selection.
5. Click the General tab and select “ASIO IFFWDMmkII Out
1” for the Playback timing master and “ASIO
IFFWDMmkII In 1” for the Record Timing master.
6. Click OK
(Note) The IF-FW/DM
MK II also supports WDM/KS mode in
Sonar. If you are using WDM/KS audio, Sonar requires you to
run “Wave profiler” on the General tab every time you change
the input or output selections or buffer sizes. See the chapter
below on the Windows Control Panel for details of how to set
the IF-FW/DM
MK II to show all of its channels to Sonar.