Qwest S1 - Manual (Page 32)

18 Section 2A: Phone Basics
Installing the Battery
To install the Li-Ion battery:
1. Insert the battery into the opening on the back of the phone (1) and
gently press down (2).
2. Place the battery cover into the position as indicated in the diagram
(3), and slide it until you hear it snap into place. Then, slide the battery
release latch.
Removing the Battery
To remove your battery:
1. Make sure the power is off so that you don’t lose any stored numbers
or messages. Slide the battery release latch (1), and then slide the
battery cover and remove it (2).
2. Use your thumbnail to lift and then remove the battery as indicated in
the diagram (3).
2
1
3
WARNING Do not handle a damaged or leaking Li-Ion battery as you can be
burned.
3
2
1