Connecting a power cable, Installing the lto driver, Registering your tape drive – Quantum Tape Drive LTO-3 User Manual
Page 32: Installing a desktop lto-3 tape drive
Chapter 2 Installation
Installing a Desktop LTO-3 Tape Drive
18
LTO-3 Tape Drive User’s Guide
Connecting a
Power Cable
2
Attach a four-pin power cable to the power connector on the back of the
drive.
shows the location of the power connector.
The recommended 4-pin power connector for internal drives is an AMP
1-48024-0 housing with AMP 60617-1 pins or equivalent.
Installing the LTO
Driver
2
If you intend to use your drive with the Microsoft native backup applet
on Windows Server 2003, Windows XP, or Microsoft Windows 2000
operating system, install the appropriate LTO driver. See the Resource
CD.
This driver is not necessary with commercial backup application
software.
Registering Your
Tape Drive
2
After you install the internal tape drive, be sure to register it. Registering
your drive ensures that you will receive the latest information about your
drive, as well as other product, service, and support information. For
your convenience, you can register your drive through our Web site at
www.quantum.com/registration
.
Installing a Desktop LTO-3 Tape Drive
2
The desktop LTO-3 Tape Drive is a compact subsystem that connects to
the host computer through a SCSI port. Installing a desktop drive
involves the following steps:
1
2
3
4
5