Quantum Tape Drive LTO-3 - Manual (Page 29)

Chapter 2 Installation
Installing an Internal LTO-3 Tape Drive
LTO-3 Tape Drive User’s Guide 15
Figure 7 Rear View of
the Internal LTO-3
Tape drive
Checking the SCSI
Termination
2
The Internal LTO-3 Tape Drive does not provide SCSI termination. You
must place a SCSI bus terminator or a SCSI device with termination
enabled at the end of the SCSI chain. Two examples of SCSI termination
are shown in figure 8 .
The Internal LTO-3 Tape Drive provides terminator power if a jumper is
placed on the termination power jumper pins (see Terminator Power ).
Caution:
Install an LVD drive only in an LVD environment.
Serial Library
Port
68-pin SCSI
connector
Drive configuration
jumper pins
Power
connector
Pin 1