Quantum Tape Drive LTO-3 - Manual (Page 26)

Chapter 2 Installation
Installing an Internal LTO-3 Tape Drive
12 LTO-3 Tape Drive User’s Guide
Figure 4 Internal
LTO-3 Tape Drive
Mounting Dimensions
Connector Detail 2 Two connectors are specified, a fixed board connector and a free cable
connector.
ADI Fixed Board Connector 2
The fixed board connector (see figure 5 ) is intended to be attached to a
circuit board in a removable medium device. It may also be used in the
automation device containing the removable medium device. The
attachment of the connector to the circuit board that is, surface mount or
through-hole) is beyond the scope of this standard. The location of the
84.3
147.8
48.90 ± 0.60
From Upper Bezel
Mounting Tabs
48.90 ± 0.60
From Upper Bezel
Mounting Tabs
Length of Drive
without Bezel
(Less connectors)
(Less connectors)
205.0 Max.
212.0 Max.
4 x M3.0 x 5.0 Deep
9.90 ± 0.20
189.70 ± 0.20
146.05 ± 0.25
79.24 ± 0.20
21.80 ± 0.20
79.24 ± 0.20 55.9
82.6 Max
4 x M3.0 Nearside
4 x M3.0 Farside