Quantum Tape Drive LTO-3 - Manual (Page 28)

Chapter 2 Installation
Installing an Internal LTO-3 Tape Drive
14 LTO-3 Tape Drive User’s Guide
Figure 6 ADI Free
Cable Connector
When the ADI free cable connector is used on both ends of a cable, like-
numbered pins shall be connected together, that is, pin 1 on end A is
wired to pin 1 on end B, pin 2 on end A to pin 2 on end B, and so forth.
Connecting a SCSI
Cable
2
The internal LTO-3 Tape Drive has an Ultra 160 SCSI interface,
terminated by a 68-pin LVD SCSI connector. Use the following procedure
to connect a SCSI cable to this connector.
1 Turn off all power to the drive and the computer.
2
Attach the SCSI interface cable to the 68-pin SCSI interface connector
on the back of the drive (see figure 7 ).