Figure 2, Internal lto-3 tape drive jumper settings, Table 1 – Quantum Tape Drive LTO-3 User Manual
Page 23: Tape drive
Chapter 2 Installation
Installing an Internal LTO-3 Tape Drive
LTO-3 Tape Drive User’s Guide
9
and 7–8 to change the SCSI ID of the LTO-3 Tape Drive (see
and
), or assign a unique SCSI ID to the other SCSI device.
Figure 2 Internal
LTO-3 Tape Drive
Jumper Settings
Table 1 ISCSI IDs
and Jumper Settings
for an Internal LTO-3
Tape Drive
Note:
The SCSI controller or host adapter generally uses ID 7. In
some systems, the boot drive uses ID 0 or ID 1. Avoid setting
your drive’s SCSI ID to these settings.
SCSI ID
Jumpers
1–2
3–4
5–6
7–8
0
Open
Open
Open
Open
1
Shunted
Open
Open
Open
SCSI ID=0
SCSI ID=1
SCSI ID=2
SCSI ID=3
SCSI ID=4
SCSI ID=5
SCSI ID=6
SCSI ID=7
SCSI ID=8
SCSI ID=9
SCSI ID=10
SCSI ID=11
SCSI ID=12
SCSI ID=13
SCSI ID=14
SCSI ID=15
Term. power
Pins:
Function
:
1-2 SCSI ID bit 0
3-4 SCSI ID bit 1
5-6 SCSI ID bit 2
7-8 SCSI ID bit 3
9-10
Reserved
11-12 Termination Power
Drive Configuration Jumpers Pins
Jumper Settings
Drive Configuration
Jumpers Pins
Default
Settings: