Oki PM4410 - Manual (Page 28)

E-26 Pacemark 4410 Setup Guide
Rear Feed Continuous Forms
Paper Specifications: Rear Feed
Maximum thickness: 0.014 inch (0.36 mm)
Type Weight Width
Single Part 12 to 24 lb. (45 to 90 g/m 2 ) 3* to 16.5 inches (76 to 419 mm)
Carbonless 9 to 11 lb. (34 to 41 g/m 2 ) 3* to 16.5 inches (76 to 419 mm)
(1 + 5 max.)
Interleaf 9 to 14 lb. (34 to 52.5 g/m 2 ) 3* to 16.5 inches (76 to 419 mm)
(1 + 3 max) 9 lb. (34 g/m 2 ) carbon
* For paper widths less than 4 inches (102 mm), remove the support between the
tractors.
When using paper which is thicker than 7-part carbonless or
its equivalent, you must enter the Menu mode, then go to the
Impact Mode item in the Set-Up group and select High
Impact Copy as the setting.
To load rear-feed paper:
Preparation
1. Position the printer at the rear edge of the support (this promotes the
unrestricted flow of paper into the printer), then place a stack of
continuous forms below the printer. Recommended height of printer
support, 29.5 inches (750 mm).