Onkyo TX-NR3008 - Manual (Page 93)

93
En
You’ll need to enter a code for each component that you
want to control.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via
, use the
following remote control codes:
• BD/DVD
`
30627:
Onkyo DVD player without
• TV/CD
`
71817:
Onkyo CD player without
` 11807:
TV with
If you want to control an Onkyo component by pointing
the remote controller directly at it, use the following
remote control codes:
`
32900:
Onkyo Blu-ray Disc player
`
32901:
Onkyo HD DVD player
` 70868:
Onkyo MD recorder without
` 71323:
Onkyo CD recorder without
` 82990:
Onkyo Dock without
Entering Remote Control Codes
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down REMOTE MODE to which
you want to enter a code, press and hold down
DISPLAY (about 3 seconds).
The REMOTE MODE button lights.
Note
• Remote control codes cannot be entered for RECEIVER
and ZONE.
• Only TV remote control codes can be entered for TV.
• Except for RECEIVER, TV and ZONE, remote control
codes from any category can be entered as REMOTE
MODE. However, these buttons also work as input selec-
tor buttons (
➔ 28), so choose a REMOTE MODE that
corresponds with the input to which you connect your
component. For example, if you connect your CD player
to the CD input, choose TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
REMOTE MODE button flashes twice.
If the remote control code is not entered success-
fully, REMOTE MODE button will flash once
slowly.
Remote Control Codes for Onkyo
Components Connected via
1
Make sure the Onkyo component is connected
with an
cable and an analog audio cable
(RCA).
See “Connecting Onkyo Components” for
details ( ➔ 23).
2
Enter the appropriate remote control code for
REMOTE MODE.
• BD/DVD
` 31612:
Onkyo DVD player with
• TAPE
` 42157:
Onkyo cassette tape deck with
• TV/CD
` 71327:
Onkyo CD player with
• PORT
` 81993:
Onkyo Dock with
See the previous section for how to enter remote
control codes.
3
Press REMOTE MODE, point the remote control-
ler at the AV receiver, and operate the component.