One for All URC 4080 - Manual (Page 18)

35
USING THE VIDEO CONFIGURATION MODE
An Example Video Configuration (Continued)
5. Press TV once and then press VOL+. The LED
will blink twice.
6. Press CBL/SAT once and then press CH+. The
LED will blink twice.
7. Press CBL/SAT once and then press MENU. The
LED will blink twice.
8. Press TV once and then press PIP. The LED will
blink twice.
9. To lock in the Video Configuration, press SET
until the LED blinks twice, then release SET.
34
TROUBLESHOOTING
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM: LED blinks when you press a key, but home
entertainment component does not respond.
SOLUTION: Make sure you are aiming the remote control at
your home entertainment component and that
you are within 15 feet of the component you are
trying to control.
PROBLEM: The remote control does not control home enter-
tainment components or commands are not per-
forming properly.
SOLUTION: Try all listed codes for the component brand
being set up. Make sure all components can be
operated with an infrared remote control.
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo
units may require both a TV code and a VCR
code for full operation (see page 16).
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume Lock
(see page 27).
PROBLEM: CH+ , CH – , and PREV.CH do not work for your
RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the original
remote control will operate these functions.
PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required pressing
ENTER to change channels, press ENTER on the
remote control after entering a channel number.
PROBLEM: Tried “Search Method” and still could not find a
working code.
SOLUTION: For help, call our technical support group at
1-330-405-8608 on any business day, between
9
A . M . and 5 P . M ., EST.
PROBLEM: Remote control does not turn on Sony or Sharp
TV/VCR Combo.
SOLUTION: For power on, these products require program-
ming TV codes on the remote control. For Sony,
use TV code 0000 and VCR code 0032. For Sharp,
use TV code 0093 and VCR code 0048.