One for All URC 4080 - Manual (Page 16)

Programming A Secondary Master Power Key
With Instant Channel Selection
Just like the M.POWER key, any F key can be programmed
to turn on and off your equipment.As an example, you
want your child to be able to easily turn on the equipment
and select a favorite premium channel.You can setup a
sequence using two macros on one F key – the first
macro will turn on the TV and tune it to channel 3, and
the second macro will turn on the Cable Box and tune it
to a desired channel (e.g., 11).
1. On the remote control, press and hold SET until
the LED blinks twice, then release SET.
2. Enter 9 - 9 - 5. The LED will blink twice.
3. Select an open F key (e.g., F2) and press
it once.
4. Enter the following sequence:
TV,
POWER, and
0- 3 (or 0 -0 - 3 if access is over 100 channels)
5. Press and hold SET until the LED blinks twice,
then release SET.
6. Repeat steps 1 through 5, but this time in
step 4 enter the following sequence:
CBL/SAT,
POWER, and
1- 1 (or 0 -1- 1 if access is over 100 channels)
Now when you press F2 once, the TV will turn on and
tune to channel 03.When you press F2 once again, the
Cable Box will turn on and tune to channel 11.
Clearing A Macro
1. On the remote control, press and hold SET until
the LED blinks twice, then release SET.
2. Enter 9 - 9 - 5. The LED will blink twice.
3. Select an F key (e.g., F1~ F4) you want to clear
and press it once.
4. Press and hold SET until the LED blinks twice,
then release SET.
31 30
USING MACROS
With programming, the F1 through F4 keys on your One
For All 4-Device Video Expert remote control can be setup
to perform repetitive, time-consuming operations for easy,
convenient access through the press of a single key.
The F keys are ideal for home theater operations, setting a
favorite channel, adding to multiple component uses,
guide steps, or other multiple functions you would like to
control with one key press.
For the optimum in individual customization, you can
define and program a sequence of events, since each F
key can hold up to three macros or 12 key presses total.
Below are a few examples to get you started.
NOTE: Programming a new macro over an existing one will erase
the original macro.
Programming A Favorite Channel
With so many channels available through your cable
system or satellite provider, you can program a macro
that directly selects a favorite channel with one key press.
For example, let’s assume your favorite cable programs
are on channel 71. Use the following instructions to pro-
gram an F key for direct access of this channel:
1. On the remote control, press and hold SET until
the LED blinks twice, then release SET.
2. Enter 9 - 9 - 5. The LED will blink twice.
3. Select an open F key (e.g., F1) and press
it once.
4. Press TV once.
5. Enter the channel number, 7 - 1.
NOTE: If you have access to over 100 channels, enter
in 071.
6. Press and hold SET until the LED blinks twice,
then release SET.
Now when you press F1, you will instantly see cable
channel 71 on your TV set.