Onkyo TA-RW544 - Manual (Page 14)

14
Connecting ONKYO Components for z
Operation
If this unit is properly connected to another ONKYO component bearing the z symbol, you will be able to control it using the other
component’s remote control.
For remote control operation
The upper and lower remote control jacks
have the same function.
For remote control operation, connect this
jack to any ONKYO amplifier, receiver or
CD player that are equipped with a z
remote control jack using the remote
control cable.
Note:
Do not attempt to connect the z remote
control jack to any equipment other than an
ONKYO component that are equipped with
a z remote control jack. Doing so could
cause the unit to malfunction.
The function listed below can be accom-
plished using the remote control of the
master unit.
s a : Play
d : Rewind
f : Fast forward
e : Stop
t : Rec/Pause
CD synchro recording system
Once connections are made, as shown left,
this function becomes enabled. It automati-
cally starts recording on the cassette deck
when the s button of the CD player is
pressed. (See below.)
CD Synchro Recording System
Once the TA-RW544/344 is connected to a CD player bearing the z symbol (see above), pressing the s button of the CD player will
cause recording to begin automatically on the TA-RW544/344. Three recording methods are possible. (See pages 8 - 11.)
1. Prepare for recording.
(See pages 8 - 11.)
2. Start the CD player.
Recording will begin simultaneously.
Note:
Even if the CD player is stopped during
recording, the cassette deck will continue
recording. In this case, make sure to press
the e button on the cassette deck.
2
s
6 DISC
1 2 3 4 5 6 7 8 9 0 +10
Tuner
CD player
Main amplifier
Pre amplifier
TA-RW544
TA-RW344