Optoma TSFN-IR01 - Manual (Page 14)

Installation
Powering On the Projector
1. Remove the lens cap. 
2. Securely connect the power cord and signal cable. When
connected, the power led will turn red.
3. Turn on the lamp by pressing “ ” button on the control
panel. The power led will now flash blue.
The startup screen will display in approximately 30 seconds.
The first time you use the projector, you can select your
preferred language from quick menu after the startup screen
display.
4. Turn on your source that you want to display on the screen
(computer, notebook, video player, etc). The projector will
detect the source automatically and will display on the
screen. If not, push menu button and go to “Options”. Make
sure that the “Source Lock” has been set to “Off”.
▀ ■ If you connected multiple sources at the same time, press the
“Source” button on the control panel or direct source key on
the remote control to switch between inputs.
Powering On/Off the Projector
Turn on the projector
first and then select the
signal sources.
/
/
/
/
/ / / /
2 1
N
ote
N
ote