Oki C710n - Manual (Page 42)

42 – C710n User’s Guide
PCL
Setup
(cont.)
) Pen Width
Adjust
On/Off When minimum width is
specified in PCL, sometimes a
1-dot line, looks broken.
With PEN WIDTH Adjust set to
ON, when the minimum width is
specified, the line width will be
emphasized so as to look wider
than a 1-dot line.
With PEN WIDTH Adjust set to
OFF, the line will appear as
before.
Tray 2 ID# 1 ~ 5 ~ 59 Sets the # to specify Tray 2 for
the paper feed destination
command (ESC&l#H) in PCL5e
emulation.
(Displayed only if Tray 2 is
installed).
Tray 3 ID# 1 ~ 20 ~ 59 Sets the # to specify Tray 3 for
the paper feed destination
command (ESC&l#H) in PCL5e
emulation.
(Displayed only if Tray 3 is
installed).
MPTray
ID# 1 ~ 4 ~ 59 Sets the # to specify the MP
tray for the paper feed
destination command
(ESC&l#H) in PCL5e emulation.
IBM PPR
Setup Character
Pitch 10 CPI
12 CPI
17 CPI
20 CPI
Proportional Specifies character pitch in IBM
PPR emulation.
Font
Condense 12CPI to
20CPI
12CPI to 12CPI Specifies 12CPI pitch for
Condense Mode.
Character
Set SET-2
SET-1 Sets a character set.
ITEM SETTINGS EXPLANATION