4-2 direct connection lamps – Omron NT20M User Manual
Page 47
43
2-4-2
Direct Connection Lamps
Creating
Use the following procedure to create a direct connection lamp.
1, 2, 3... 1.
Select LAMP from the Initial Edit Display, a list of the lamps already ex-
isting in the current screen will be displayed.
2.
Specify the number to be used in the table. The numbers in this table
are not the lamp numbers. When a number is specified, a display to
specify either a rectangular or round lamp will appear.
3.
Specify the lamp shape. A display will appear to draw the lamp.
4.
If a rectangle was specified, specify the starting and ending points (diag-
onally opposed corners) of the rectangle. If a circle was specify, desig-
Lamps
Section 2-4