Omron NT20M - Manual (Page 117)

113
5. Input the number of the screen where you want the received data to be
stored, and then press the Enter Key. A message will be displayed ask-
ing whether you actually want to receive the data.
6. To confirm, press the Enter Key. To return to step 1, press any key other
than the Enter Key.
7. When the reception is complete, a message will be displayed. Press any
key to return to the Screen Selection Display.
Note 1. If screen data already exists at the screen designated for storage, a mes-
sage will appear indicating that data already exists at the designated
number and asking you if you wish to overwrite that data. If it is overwrit-
ten, any data stored up to that point will be cleared. If you wish to over-
write the existing file, press the Enter Key. If you wish to cancel, return to
step 1 by pressing a key other than the Enter Key.
2. Before receiving continuous or overlapping screens, check carefully to
ensure that the Support Tool has no errors in screen data.
Receiving Memory Tables
Note The content of memory tables received from the PT will always be the initial
data set via the Support Tool.
Receiving Data Section 6-3