Optoma RMC-25key - Manual (Page 3)

3
English
Usage Notice
 When the lamp
reaches the end
of its life, the
projector will
not turn back on
until the lamp
module has
been replaced.
To replace the
lamp, follow
the procedures
listed under
“Replacing the
Lamp” section
on pages 48-49.
Precautions
Please follow all warnings, precautions and
maintenance as recommended in this user’s
guide.
▀ ■ Warning- Do not look into the projector’s lens when the lamp is
on. The bright light may damage your eyes.
▀ ■ Warning- To reduce the risk of fire or electric shock, do not
expose this projector to rain or moisture.
▀ ■ Warning- Please do not open or disassemble the projector as
this may cause electric shock.
▀ ■ Warning- When replacing the lamp, please allow unit to cool
down, and follow all replacement instructions.
See pages 48-49.
▀ ■ Warning- This projector will detect the life of the lamp itself.
Please be sure to change the lamp when it shows
warning messages.
▀ ■ Warning- Use the “Lamp Reset” function from the on-screen
display “Options|Lamp Settings” menu after
replacing the lamp module (refer to page 42).
▀ ■ Warning- When switching the projector off, please ensure the
cooling cycle has been completed before
disconnecting the power. Allow 90 seconds for the
projector to cool down.
▀ ■ Warning- Do not use the lens cap when projector is in opera-
tion.
▀ ■ Warning- When the lamp is approaching to the end of its life,
the message “Lamp Warning: Lamp life exceeded.”
will show on the screen. Please contact your local
reseller or service center to change the lamp as soon
as possible.
▀ ■ Warning- To reduce the risk of injury to the eyes, do not look
directly into the laser beam on the remote control
and do not point the laser beam into anyone’s eyes.
This remote control is equipped with a Class II laser
that emits radiation.