Onkyo TXNR1008 - Manual (Page 7)

Update Procedure via USB
7
Step 1:
Connect a USB storage device to your PC. If there is any
data in the USB storage, remove it.
Step 2:
Download the firmware file from the Onkyo web site.
The file name is as follows:
ONKAVR0001_*******.zip
Unzip the downloaded file. The following three files are
created:
ONKAVR0001_*******.of1
ONKAVR0001_*******.of2
ONKAVR0001_*******.of3
Step 3:
Copy the extracted files to the USB storage device. Be
careful not to copy the zip file.
Step 4:
Remove the USB storage device from your PC and
connect it to the USB port on the AV receiver/controller.
When the AV receiver/controller has two USB ports,
you can use either one.
Step 5:
Make sure your AV receiver/controller and TV are
turned on.
If the AV receiver/controller is in standby mode, push
[ON/STANDBY] to light up the front display.
Step 6:
Select the USB input source. “Now Initializing” is
displayed on the front display and then the name of the
USB storage device is displayed. It will take 20 to 30
seconds to recognize the USB storage device.
Step 7:
Push [RECEIVER] followed by [SETUP] on the remote
controller.
Main menu will be displayed on TV screen.
Procedures thereafter can also be performed on the
AV receiver/controller by using its SETUP, arrow, and
ENTER buttons.
Step 8:
Go to “Hardware Setup” menu.
Step 9:
Go to “7-7. Firmware Update” menu.
Step 10:
Select “Via USB” and push [ENTER].
Step 11:
Select “Update” and push [ENTER].
Updating will begin.
As the updating progresses, the TV screen may
disappear depending on the program updated. In this
case, you can see the update progress on the front
display of the AV receiver/controller. The TV screen
will reappear when you finish the update and turn on the
AV receiver/controller.
Do not turn off the AV receiver/controller and do not
remove the USB storage device during updating
process.
Step 12:
Message “Complete!” appears on the front display of the
AV receiver, indicating that the update has been
completed
Step 13:
Using the [ON/STANDBY] button on the front panel,
turn off the AV receiver/controller and then remove the
USB storage device.
* Do not use the ON or STANDBY button on the remote controller.
Step 14:
Push ON/STANDBY to turn on the AV
receiver/controller.
Congratulations!! Now you have the latest firmware on
your Onkyo AV receiver/controller.