Onkyo TXNR1008 - Manual (Page 6)

Firmware Update via USB
6
TX-NR708/808/1008 and HT-RC270 allows you to
update firmware using a USB storage device.
*In this procedure, on-screen display may vary
depending on the model.
Notes
• Make sure the AV receiver and TV are turned on.
• Never unplug or turn off the AV receiver during
• updating process.
• Never plug or unplug an HDMI cable during
• updating process.
• Never unplug the USB storage device containing
• the firmware file and the AC power cord during
updating process.
• Do not access the AV receiver from PC during
updating process.
• It will take about 30 minutes to update the firmware.
• The AV receiver will retain all your settings after
update is finished.
Before you start
• Check HDMI Control (RIHD) setting. The update
may not be successful if this setting is on.
• Turn off the controller device connected via
• RS232C and via Ethernet network.
• Turn off Zone 2 and Zone 3.
• Stop playback of content from Internet radio, iPod,
USB or servers, etc.
• Receiver MUST be in USB mode BEFORE
performing firmware update
To place receiver in USB Mode:
1. Power on the Receiver
2. Press the Net/USB input selector
button 3 times
Initial display
If no USB device is attached
If USB Device is attached
3. Receiver needs to remain in this mode until procedure is
complete
4. How to turn off RIHD
In the Main menu select “Hardware Setup”.
Select “HDMI”.
Set “HDMI Control (RIHD)” to “Off”.
1
2
3