Onkyo TX-SE550 - Manual (Page 29)

29
Programming remote controller codes
1. Press the LEARN button.
2. Place the head of your old remote controller 2-4 inches (5-10
cm) from the head of the RC-386M, laying both units on a
table or a flat surface.
3. On the RC-386M, press the button in the PROGRAMMA-
BLE AREA into which you want to store the code.
•
The SENDING/LEARNED indicator lights up.
4. On your old remote controller, hold down the button for the
function you want the RC-386M to memorize while the
LEARNED indicator is lit. Keep pressing this button until it
turns off.
•
To store a code to another button, repeat steps 1-4.
NOTES:
•
Some remote controllers use a single button to perform different
functions, with the function code changing each time the button
is pressed. If you are using this kind of controller, please per-
form the “learn” operations for each function individually to
store each function to a button on the RC-386M.
•
For instructions regarding the operation of “learned” units,
please refer to the instruction manual for each product.
•
Even after codes have been memorized, please keep your old
remote controller in a safe place. If the memorized codes are
lost when the batteries run down, it will be necessary to memo-
rize them once again using the old remote controller.
Reprogramming the buttons:
Follow the steps 1-4 described above. The previous codes will be
lost, and new codes will be stored.
Please check whether previously-memorized functions are working
properly. If the SENDING indicator is not illuminated when a pro-
grammed button is pressed, it may need to be relearned from your
old remote controller.
Then operate the remote controller by pressing the buttons of the
functions you want to use.
•
If you press a button that has no code stored, the SENDING/
LEARNED indicator will not light up.
1. Press the LEARN button.
2. Press and hold the POWER and VOLUME † buttons
together until the SENDING/LEARNED indicator turns off.
•
All codes stored in the programmable area will be deleted.
Leaning new controller codes
Operating the RC-386M
Clearing all memorized codes
LEARN button
POWER SLEEP
DVD VIDEO-1 VIDEO-2
TAPE PHONO C D LEARN
INPUT SELECTOR
DIMMER
TUNER
TEST
TONE
SENDING/
LEARNED
MULTI-CH
INPUT
SUR
MODE
2
3
4
Light 5 to 10 cm
(2 to 4 inch)
The button you wish to memorize
RC-386M
1
POWER SLEEP
DVD VIDEO-1 VIDEO-2
TAPE PHONO C D LEARN
INPUT SELECTOR
KARAOKE
VOCAL
CANCEL
KEY CONTROL
VOLUME
DIMMER
TUNER
POWER
POWER
VOLUME C H
MUTING
LEVEL
REMOTE CONTROLLER
CH SEL
TEST
TONE
SENDING/
LEARNED
PROGRAMMABLE AREA TV/VIDEO
MULTI-CH
INPUT
RC-386M
SUR
MODE
1
2