Onkyo TX-SE550 - Manual (Page 24)

24
Tuning in a radio station
FM
AM
√ TUNING ®
FM MUTE/MODE
DIRECT TUNING
Number buttons
BASS TREBLE
C D PHONES
Re-EQ
A/V KARAOKE CONTROL RECEIVER TX-SE550
AM FM DVD PHONO 1 VIDEO 2 VIDEO TI CH INPUT MUL TAPE( ) MONITOR
CLEAR
MEMORY FM MUTE / MODE SPEAKERS A B MIDNIGHT THEATER SURROUND MODE
MASTER VOLUME
OFF ON
POWER
STANDBY/ON
ECHO LEVEL
3-D BASS
MIC LEVEL
KARAOKE
MIC 1 2
1
MAX MIN
2
MAX MIN MAX MIN
KEY CONTROL VOCAL CANCEL SCAN GROUP DIRECT TUNING
STANDBY
1 2 3 4 5 6 7 8 9 0 /10 TUNING PARAMETER CONTROLLER
PARAMETER SELECTOR
1. Press the FM or AM button.
2. Use the TUNING √/® buttons to change the frequency.
® (up) ..............the frequency increases.
√ (down) .........the frequency decreases.
•
The frequency changes in 50 kHz steps in FM and 10 kHz (or
9 kHz) in AM each time you press the TUNING √/® button.
•
In FM, if this button is held continuously for more than 0.5 sec-
onds, the frequencies are scanned automatically (FM auto tun-
ing mode). When a broadcast is received, scanning stops.
1. Press the FM or AM button.
2. Press the DIRECT TUNING button.
The “_ _” will flash 16 seconds in the frequency display.
3. Enter the frequency using the number buttons while the
cursor is flashing.
Example: 88.10 MHz
50 kHz step area, 8
→
8
→
1
→
0/10
100 kHz step area, 8
→
8
→
1
Use the 0/10 number button to enter a 0.
•
Out-of-range frequencies will be ignored.
•
When receiving AM broadcasts with a 10 kHz steps, entering a
number for the 10 kHz digit will set the 1 kHz digit to 0.
When an RDS (Radio Data System) station broadcasting PS (Pro-
gram Service Name) information is received, the RDS indicator
lights up and the name of the station is displayed.
•
RDS reception is only available on the European model, and
only in areas where RDS broadcasts are available.
When you tune in a stereo FM station, the FM STEREO indicator
lights up if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune in to the desired
station. In this case, tune in as follows.
Press the FM MUTE/MODE button. The FM MUTE indicator
turns off. At this time, the station will be in mono and interstation
noise will be heard. Select the station to which you want to listen.
Manual tuning
Direct tuning
Receiving RDS (European model only)
Listening to a stereo radio station (FM mode)
AM FM
SPEAKERS A SPEAKERS A
TUNING SPEAKERS A FM STEREO
MHz
VIDEO 2
TUNED FM MUTE
1
2
CLEAR
MEMORY FM MUTE / MODE
1
2
3
AM FM
SPEAKERS A SPEAKERS A
SPEAKERS A FM STEREO
MHz
VIDEO 2
TUNED FM MUTE
1 2 3 4 5 6 7 8 9 0 /10
DIRECT TUNING SPEAKERS A
MHz
VIDEO 2
FM MUTE