Olympus VP--1 - Manual (Page 60)

E-60
Info.
Resolution / Frequency
This function displays the resolution and frequency of the
detected input signal.
This information will not be displayed unless an analog RGB or
digital RGB signal is input and an Analog RGB or Digital RGB
input selection is made.
Status
Lamp Timer Reset
1024 ן768
Resolution
Factory Default
Frequency
Lamp Timer 12h
60Hz, 48kHz
Lamp Timer
This function displays the lamp timer.
When the lamp timer exceeds 1000 hours, “Replace the Lamp
Cartridge” is displayed on the screen for 10 seconds at one minute
intervals.
Replace the lamp with a new one.
See “Replacing the lamp cartridge” on
Page E-66 for information
about lamp cartridge replacement.
When 1100 hours is exceeded, “Warning!! System Shutdown” is
display for 10 seconds and the power is switched off.
Status
Lamp Timer Reset
1024 ן768
Resolution
Factory Default
Frequency
Lamp Timer 12h
60Hz, 48kHz