Olympus VP--1 - Manual (Page 25)

E-25
Power Cable Connections and Switching the Power On/Off
Finishing
1
Switch off the power of the connected equipment
2
Switch off the power of the projector
Main unit operation: Press and hold the POWER button for 1 second.
Remote control operation: Press the POWER OFF button.
ON OFF POWER
The “Power Off” indication will appear.
When the red bar extends fully (in about 5 sec-
onds), the projection screen will go off and the
unit will enter the power off operation.
Note
* The operation can be cancelled by pressing a but-
ton other than the POWER button.
* One more press of the POWER (POWER OFF)
button will switch off the power.
Power Off
OK ?
Power Off
OK ?
STATUS POWER STATUS POWER STATUS POWER
POWER
Blinks amber
(Approximately 90
seconds)
Lit amber
Standby
mode
The POWER indicator changes to blinking am-
ber and lights a steady amber after about 90 sec-
onds (when the unit enters the standby mode).
3
Unplug the power cable
Check that the sound of the cooling fan is quieter and that the POWER indicator is lit steadily
in amber, then unplug the power cable.
The POWER indicator will go off when the power cable is unplugged.
Warning
Do not disconnect the power cable while the POWER indicator is blinking in amber. Doing so
could shorten the life of the lamp or lead to breakdown of the projector.