ooma Scout - Manual (Page 40)

installing the ooma scout
Now that you’ve installed your ooma Hub device, all that’s left to do is install your ooma Scout devices. Each
additional phone you want to use with the ooma system must be connected to an ooma Scout.
Your initial setup will look like:
Connect a phone to an ooma Scout:
1
If you have DSL, trace the phone cable to the wall. Unplug and remove any existing DSL filters or
splitters. Note: Some DSL filters and splitters are mounted flat on the wall jack.
2
Unplug the phone cable from your phone and plug it into the port labeled WALL on the ooma Scout.
3
Use a phone cable to plug your phone into the port labeled PHONE on the ooma Scout (a short phone
cable is provided).
4
Plug one end of the AC adaptor into the port labeled POWER on the ooma Scout and the other end into
a power outlet.
Now your setup should look like this:
Within 30 seconds, the clear ooma Tab at the top left corner should turn blue. Pick up the phone connected to
the ooma Scout and you should hear the signature ooma dialtone.
WALL PHONE
Phone Jack Power
Phone Jack Phone Jack
DSL Filter