Onkyo Network A/V Receiver TX-NR1010 - Manual (Page 79)

Advanced Operations
En-79
OSD Setup
■ On Screen Display
` On
` Off
This preference determines whether operation details are
displayed on-screen when an AV receiver function is
adjusted.
Even when “On” is selected, operation details may not be
output if the input source is connected to an HDMI IN.
■ Language
(North American models)
` English, Deutsch, Français, Español, Italiano,
Nederlands, Svenska
(European models)
` English, Deutsch, Français, Español, Italiano,
Nederlands, Svenska,
This setting determines the language used for the on-screen
menus.
■ Screen Saver
` 3min, 5min, 10min
` Off
With this setting, you can set the time until the screen saver
activates itself. Once active, the screen saver will go off
and the screen will return to its previous state if the AV
receiver is operated in any way.
Main Menu Hardware Setup
Tuner
■ AM/FM Frequency Step (North American
models)
` 10kHz/200kHz:
` 9kHz/50kHz:
Select the frequency step according to your area.
■ AM Frequency Step (European models)
` 10kHz:
` 9kHz:
Select the frequency step according to your area.
For AM/FM tuning to work properly, you must specify the
AM/FM frequency step used in your area.
Note
• When this setting is changed, all radio presets will be deleted.
HDMI
■ HDMI Control(RIHD)
` Off
` On
Turn this setting on to allow -compatible
components connected via HDMI to be controlled by the
AV receiver (
➔ page 111 ).
Note
• When the setting is set to “On” and the menu is closed, the names
of connected -compatible components and “RIHD On”
are displayed on the AV receiver.
“Search…”
→ “(name)” → “RIHD On”
When the AV receiver cannot receive the name of the component,
it is displayed as “Player
* ” or “Recorder * ”, etc. (“ * ” shows up
and indicates the number of components, when two or more are
received).
• When an -compatible component is connected to the
AV receiver via an HDMI cable, the name of the connected
component is displayed on the AV receiver display. For example,
while you are watching TV broadcasting, if you operate a Blu-ray
Disc/DVD player (being powered on) with the remote control of
the AV receiver, the name of the Blu-ray Disc/DVD player will
be displayed on the AV receiver.
• Set it to “ Off ” when a connected piece of equipment is not
compatible or it is unclear whether the equipment is compatible
or not.
• If operation is not normal when set to “ On ” , change the setting to
“ Off ” .
• Refer to the connected component’s instruction manual for
details.
• When the “HDMI Control(RIHD)” setting is set to “On”, the
power consumption on standby mode slightly increases.
(Depending on the TV status, the AV receiver will enter standby
mode as usual.)
• The HDMI component (connected to HDMI IN 1/2/3/AUX
INPUT) selected for Zone 2 cannot be operated with the remote
controller through the AV receiver using RIHD function and also
cannot be operated on the TV connected to HDMI OUT MAIN
using CEC function.
• The HDMI component (connected to HDMI IN 1/2/3/AUX
INPUT) selected for Zone 2 can be operated on the TV in Zone 2
using CEC function.
• When the source equipment is connected with the
connection, it may malfunction if “HDMI Control(RIHD)” is
set to “On”.
Hardware Setup
1 2 3 4 5
“Setup”