Oricom SECURE 700 - Manual (Page 9)

7 OpErATING ThE BABy UNIT
4 Operating the Baby Unit
Switching the baby unit on/off
Position the baby unit in a good location for the monitoring
task required and point the camera lens to the area to be
monitored.
Slide the switch to ON.
The Power LED lights up green. The baby unit is now
ready to operate.
To switch the unit off, slide the switch to OFF.
In the case of a low battery voltage, the Power LED flashes
slowly.
In this event replace the 4 x AAA batteries with new alkaline
batteries in the Baby unit.
Night vision
The baby unit is equipped with 4 infrared diodes. This
enables the transmission of pictures from areas which
are not illuminated. The night vision function is activated
automatically in low light conditions.
When the night vision function is activated, the screen display
on the parent unit turns to black and white.
Note:
If you place the Parent and Baby units too close together
you will hear a high pitched noise called "feedback", this is
normal. The units are designed to be located in separate
rooms.
To prevent feedback, do not take the Parent unit into the
nursery/baby's room.
Do not Press Talk button when the Baby unit and Parent
unit are positioned in the same room. Feedback will be
generated if the talk button is pressed when the Baby unit
and Parent unit are to close to each other.