Oricom SECURE 700 - Manual (Page 12)

10 OpErATING ThE pArENT UNIT
Power failure/portable use
In the event of a power failure or for portable use when no
mains power is available, the Baby unit will require charged
Alkaline batteries (not supplied) to operate.
Note: When using Alkaline batteries the unit will only
operate for a short period (up to 4 hours depending on the
quality of the batteries used.).
Installing Alkaline batteries
Ensure AC adaptor is not connected to the baby unit. Use
a small screwdriver to open the battery door on the base of
baby unit. Insert the 4 AAA batteries (not supplied), paying
attention to the correct polarity. Refer to the diagrams in the
battery compartment. Replace the battery compartment
and fit screw.
In the case of a low battery, the Power LED on the baby
unit flashes slowly. The batteries must be replaced.
Registration
The parent unit and baby unit are pre−registered. If
necessary, registration can be completed manually:
Baby unit/Parent unit
1 Switch the baby unit and parent unit off.
2 Cover the light sensor with a dark cloth and switch
the baby unit on. Position ON.
3 The Power LED on the baby unit flashes quickly
for approx. 15 seconds.
4 Switch the parent unit on and wait until the Oricom
logo disappears from the display and then press
and hold this button on the parent unit for a few
seconds until this icon
C1 appears in the display.
5 Press this button to confirm the selection.
6 C1.... appears initially, then C1....OK.
When a connection is established, the image viewed
by the lens appears in the display.
Note: Each step above needs to be done promptly. If C1...X
appears (registration failed), Disconnect the AC adaptor from
the parent unit and remove the batteries from the baby unit.
Wait for 2 minutes, reconnect power and replace the batteries
and try again.