Oricom SECURE 700 - Manual (Page 11)

9 OpErATING ThE pArENT UNIT
Adjusting the VOX 1 sensitivity
VOX 1 : Voice Operated Transmission = Sound detection
The VOX 1 function (sound detection) causes the
system to start transmitting automatically from the baby
unit to the parent unit only when sound is detected.
Press this button four times.
This icon appears in the display for a few seconds.
Use this button to set VOX to OFF or adjust the
sensitivity to one of 5 levels. When one of the five
levels has been set, the VOX LED lights up red and
the display goes out after 10 seconds.
Red VOX LED light illuminates to indicate VOX is
turned ON.
NOTE: VOX will not activate if lullabies are turned ON.
The display is reactivated when a sound is detected
or a button on the parent unit is pressed.
Selecting a lullaby
Press the button on the right hand side of the parent unit
to turn lullabies ON/OFF.
This icon appears in the display.
Use the button to select one of the 5 lullabies (1-5).
If no number is displayed, all of the lullabies will
continue to play in sucession until deactivated.
Use this button to adjust the volume to one of five
settings. The volume levels will be adjusted on both
the baby unit and parent unit simultaneously.
This icon appears during the volume adjustment.
NOTE: The volume cannot be turned OFF.
Lullabies will continue to play on the Baby Unit when
the Parent unit is turned OFF. To turn off the lallabies
on the baby unit turn parent unit back ON.
Intercom function
Press and hold this button to talk.
Release button when you have finished speaking.
This icon appears on the display.
Speak into the microphone to talk to the person near
the room being monitored.
When you press intercom function lullabies will be
deactivated.
Range
This icon flashes in the display and a tone will be
heard when the distance between the baby unit and
parent unit is too great.
Move the parent unit nearer to the baby unit.