Oricom SECURE 700 - Manual (Page 7)

5 USING yOUr SC700
3 Installation
Installing the rechargeable battery pack in the
parent unit
The parent unit is powered by a Rechargeable Lithium
Battery Pack. The red Power LED lights up on the Parent
unit when it is being charged. When the battery is fully
charged the red LED will turn off. In the case of a low
battery, the green Power LED flashes slowly. The parent
unit should be returned to the cradle to recharge.
!
IMPORTANT
1. Turn the belt clip upwards.
2. Open the battery compartment on the rear side of the
parent unit.
3. Insert the battery pack supplied by plugging the
connector into the socket.
4. Close the battery compartment.
5. Turn the belt clip back downwards.
6. Charge parent unit on cradle for a minimum of 12 hours
for initial charge with the parent unit turned off.
Note: The following indicates if the battery is fully charged:
Parent unit power off: the charging red led will turn off
Parent unit power on: charging red led will change to green
Only after the battery pack in the parent unit is fully
charged should you connect the baby unit to a power point.
This will help to increase the life and performance of your
battery.
Connecting and aligning the baby unit
Position the baby unit with a minimum distance of 1 m
to other electronic devices, otherwise there is a risk of
interference. Point the upper section of the baby unit
towards the baby or object you want to monitor. Check that
the baby or object is suitably displayed on the parent unit.
AC Power adaptor
Only use the AC power adaptor supplied with the product
as other power adaptors could damage the product. This
product is designed for indoor use only.
!
Warning
If you plan to use your Baby monitor whilst travelling
overseas, make sure that the voltage shown on the AC
adaptor is the same as the local mains power before
connecting to the power supply. Do not use any voltage
converter with the monitor.