Oki FAX 5250 - Manual (Page 49)

|
Handbook 49
Dial Parameter Settings
These functions allow you to control the way your fax
machine dials telephone numbers. Refer to the Dial Parameter
Settings List below to determine which settings you may need
to change, then refer to “Changing Your Dial Parameter
Settings” part of this section to make the change.
Dial Parameter Settings List
1 REDIAL TRIES
This function controls how many times your fax machine
automatically redials a number that is busy or does not
answer.
Available settings are from 0 to 10 tries.
Default: 3 tries.
2 REDIAL INTERVAL
This function controls how long your fax machine waits
between each automatic redial attempt.
Available settings are from 1 to 6 minutes.
Default: 3 minutes.
3 DIAL TONE DETECT
This function allows your fax machine to wait for and
detect a dial tone before proceeding with dialing.
Available settings are ON and OFF.
Default: OFF.
4 BUSY TONE DETECT
This function allows your fax machine to detect a busy
tone when sending a fax.
Available settings are ON and OFF.
Default: ON.
5 MF(TONE)/DP (PULSE)
This function sets the dialing method. Use the MF setting
for Touch-Tone dialing, or the DP setting for pulse dialing.
Default: MF (TONE).
6 PBX LINE
Turn this function on if your fax machine is connected to a
PBX (Private Branch Exchange—a phone system used to
route internal calls). Once this function has been turned on
and the access digit function has been programmed using
the Dial Prefix parameter (below), your fax machine